Air Compressor: Dual Flow
The P425/HP375 dual-flow air compressor can deliver air at either 425 cfm at 100 psi or 375 cfm at 150 psi. The air compressor is powered by a Cummins QSB 4.5L diesel engine that meets Tier 4 Final emissions standards. The five-gallon diesel-emission fluid tank needs to be refilled only once every two diesel refills. The compressor’s electronically controlled cooling fan activates only at higher temperatures, saving fuel and lowering overall noise levels.
Doosan Portable Power; www.doosanportablepower.com
Carrydeck crane: Tier 4 Final Engine
The GCD25 is the first model in the new line of Grove carrydeck cranes. The crane boasts a 25-ton capacity and a four-section, 71-ft boom. The crane has an operating weight of 22.7 tons and a maximum tip height of 95 ft. Cranes in the new carrydeck line run on engines that meet Tier 4 Final emissions standards. The crane has four-wheel drive as well as four-wheel steering capabilities. The four-position pivoting boom head allows the crane to work in spaces with low overhead clearance.
Manitowoc Co.; www.manitowoc.com
Tracked Material carrier: 360° of Rotation
The RT14R Carrier features 360° of rotation, allowing it to dump material at any position, even while driving. The 20-ton machine has a carrying capacity of 14 tons, with 7.9 psi of ground pressure when fully loaded. The rotating frame allows for material to be placed without repositioning the vehicle, reducing damage to the ground. The RT14R’s treads allow it to work in ground conditions that would present a challenge to wheeled dump trucks.
Terramac; www.terramac.com
Breaker: Also Works as a Tool Carrier
The second-generation CTS12 Rip-R-Stripper can be used to remove ceramic tile, hardwood flooring and other tough floor coverings. The breaker can work in nine different self-locking positions, including fully upright. It can accept mounting kits for the Hilti TE-1000-AVR breaker and work as a tool carrier for smaller, electrically powered breakers. The breaker is powered by a standard 115V power source. The wheels of the tool can be adjusted separately; this capability ensures that the chisel is properly aligned with the floor surface, reducing uneven wear on the chisel.
General Equipment; www.generalequip.com
Manufacturers can send information on new products to ENR.products@bnpmedia.com.
