Cement Mixer: Mounts to Auger Drive                                                                    

The Digga cement mixer has a maximum mixing capacity of 4 cubic ft and can fit Digga’s line of auger drives for skid-steer loaders, front-end loaders and telehandlers. In a matter of minutes, the mixer mounts to the auger drive with a simple pin attachment. It is also available for mini loaders and in a walk-behind model. Digga North America; www.diggausa.com


Luffing-Jib Tower Crane: Featured at Bauma China

The CML190 luffing-jib tower crane comes in two models, with maximum lifting capacities of 12 and 18 metric tons. The crane was announced at Bauma China, the construction-equipment trade show held Nov. 27-30 in Shanghai. The crane has a maximum reach of 60 meters, with different jib configurations every 5 m. Reaching hoist speeds of up to 178 m per second, it has a drum capacity of up to 1,280 m of wire rope. An electronic control system adjusts hoist speeds depending on the angle of the jib and features a “microspeed” mode for finer control. Linden Comansa; www.lindencomansa.com


Truck-Mounted Crane: Optional Jib Available

The 36142 boom truck is a 36-ton-class telescopic truck-mounted boom crane, with a five-section, 142-ft main boom. The boom also has an optional 32-ft to 49-ft two-section jib, pushing the crane to a maximum tip height of 201 ft. The crane has a 36-ton lift rating at a 5-ft radius and sports 21-ft outriggers with full- and mid-span lift charts. Elliot Equipment Co.; www.elliotequip.com


Wireless Speaker: Tough Case Built for the Jobsite

The M18/M12 wireless jobsite speaker works with Milwaukee’s M12 and M18 batteries. The system has six speakers and a 20W dual-channel amplifier. The speakers can play audio from any Bluetooth-enabled device. Equipped with a fast-charging USB port, it can run for 16 hours on an M18 battery or for 12.5 hours on a M12 battery. Impact-resistant frame and side caps protect the speaker, and it is water- and dust-resistant. Milwaukee Tool Co.; www.milwaukeetool.com


Manufacturers can send information on new products to ENR.products@enr.com.